Next Previous Contents

7. Serial Port Devices /dev/ttyS2, etc.

For creating devices in the device directory see

Creating Devices In the /dev directory

7.1 Serial Port Device Names & Numbers

Devices in Linux have major and minor numbers. Each serial port may have 2 possible names in the /dev directory: ttyS and cua. Their drivers behave slightly differently. The cua device is deprecated and will not be used in the future. See the Modem-HOWTO section: "The cua Device".

Dos/Windows use the COM name while the setserial program uses tty00, tty01, etc. Don't confuse these with dev/tty0, dev/tty1, etc. which are used for the console (your PC monitor) but are not serial ports. The table below is for the "standard" case (but yours could be different).

                                                  IO
 dos            major minor       major minor  address
COM1  /dev/ttyS0  4,  64;  /dev/cua0  5,  64      3F8
COM2  /dev/ttyS1  4,  65;  /dev/cua1  5,  65      2F8
COM3  /dev/ttyS2  4,  66;  /dev/cua2  5,  66      3E8
COM4  /dev/ttyS3  4,  67;  /dev/cua3  5,  67      2E8
Note that all distributions should come with ttyS devices (and many distributions have the obsolete cua device). You can verify this by typing (don't feel bad if you don't find any obsolete cua devices):

linux% ls -l /dev/cua*
linux% ls -l /dev/ttyS*

7.2 Link ttySN to /dev/modem ?

On some installations, two extra devices will be created, /dev/modem for your modem and /dev/mouse for your mouse. Both of these are symbolic links to the appropriate device in /dev which you specified during the installation (unless you have a bus mouse, then /dev/mouse will point to the bus mouse device).

There has been some discussion on the merits of /dev/mouse and /dev/modem. The use of these links is discouraged. In particular, if you are planning on using your modem for dialin you may run into problems because the lock files may not work correctly if you use /dev/modem. However, if you change or remove this link, some applications might need reconfiguration.

7.3 Creating Devices In the /dev directory

If you don't have a device, you will have to create it with the mknod command or with the MAKEDEV shell script. Example, suppose you needed to create ttyS0:

linux# mknod -m 666 /dev/cua0 c 5 64 (cua devices are now obsolete)
linux# mknod -m 666 /dev/ttyS0 c 4 64
You can use the MAKEDEV script, which lives in /dev. See the man page for it. This simplifies the making of devices. For example, if you needed to make the devices for ttyS0 you would type:
linux# cd /dev
linux# ./MAKEDEV ttyS0
This handles the devices creation and should set the correct permissions. For making multiport devices see Making multiport devices in the /dev directory.


Next Previous Contents